A frayed or snapped lift cable throws the whole door off balance, and a door hanging crooked on one cable is a genuine safety hazard. We replace cables and inspect the drums they wind onto.
When one lift cable fails, the other has seen the same wear cycle. We replace both to prevent a repeat call.
A cable can slip its groove repeatedly if the drum itself is damaged, which we check before calling the job done.
Lift cables connect directly to spring-loaded drums, so replacement requires the same careful tension handling as spring work.
Cable stock in standard gauges means most replacements happen in a single visit.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
A snapped cable leaves the door hanging unevenly on the remaining side, an unsafe condition we treat as priority.
Fraying cable strands are a warning sign of imminent failure. We replace before it snaps and drops the door unexpectedly.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
We match new drums to the correct diameter for your door's cable length requirements.
A door hanging crooked usually means one cable or spring has failed while the other holds. We correct both the immediate hazard and the root cause.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Cable stock on the truck means most calls avoid a second trip for parts.
Diagnosis includes the drums, not just the visible cable, before any price is confirmed.
Cables replaced, tension balanced, and the door tested level before we leave, backed by written warranty.
“Door was hanging at an angle after a cable snapped. They replaced both cables and it's perfectly level now.”
“Caught the fraying cable during a routine call before it actually snapped. Appreciated the heads-up.”
“Same-day fix on a Saturday, cable stock right there on the truck.”
An uneven hang points to a broken cable, a failed spring, or a bent track pulling the panel off-square.
Both cables typically get replaced together to avoid a near-term repeat call.
We treat cable failures as priority calls given the safety risk involved.
Usually a bent or worn drum groove, sometimes combined with a slightly loose cable tension setting.
Cost varies with door size and whether one or both cables and drums need attention.
A snapped-cable call usually resolves in under two hours on-site.
Call now for a real appointment window, not a callback promise.
☎ Call +1-831-293-1591From one side of Brooklyn Center to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Brooklyn Center, MN